Having replace the hammer, the grip safety and the safety lock, cock the hammer. Cock the hammer to replace the safety lock.ĥ. While retaining in this position, slide the main spring housing up in its grooves until its end is projecting only about one-eight of an inch below the edge of the bottom of the frame.Ĥ. The upper end of the left-hand leaf must rest against the sear. In replacing the sear, make sure that its lower end is caught in the slot located at the bottom rear of the frame handle. Holding them this way, insert the sear pin from the left side of the frame making sure that it passes through both the disconnector and the sear.ģ. Slightly press the trigger so that the holes of the two parts will line up with that of the frame. Put the parts together into the frame by inserting the rounded head of the disconnector in its hole in the frame so that the flat face of its lower end rests against the trigger stirrup. To do this, first mount the sear over the disconnector (curved section inward, lugs pointing downward}. The disconnector and sear are assembled together and it is important that they be in proper position. Then slide the frame forward into the slide rails.Ģ. Make sure that the barrel link is tilted to the front as far as it will go and that the barrel link pi is flush in its seat. When the barrel and slide assembly is to be mounted on the frame, hold both the slide and the frame bottom side up. While reassembly of the dismantled pistol is done in the reverse order of disassembly, the following special instruction will be of assistance:ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |